Inflatable Barrel Ice Bath

The tub ships with a full kit covering inflation, drainage, and chiller connectivity. Three colour-coded ports on the back panel — Water In, Air Valve, and Water Out — allow the tub to be connected directly to an electric chiller unit or used with manual ice. Pre-drilled watertight caps are fitted from the factory, so a chiller can be added at any point without modification.

When deflated, the tub packs down small enough to fit inside the included heavy-duty carry backpack, making it practical for temporary setups, travel, or venues that need equipment stored between sessions. An insulated thermal lid with safety buckles is included to slow heat gain between uses.

• Drop-stitch military-grade PVC walls inflate to a rigid, non-flexing structure that holds 397L of water
• 105-gallon (397L) capacity suits most adults for a full-immersion plunge
• Three colour-coded rear ports (Water In, Air Valve, Water Out) allow direct chiller connection or manual ice use
• Insulated thermal lid with safety buckles reduces heat gain between sessions
• Rapid-drain bottom valve and extendable hose direct water away during changeovers
• Deflates and packs into the included carry backpack for transport or compact storage
• PVC patch repair kit included for field maintenance
• Easier to clean than fibreglass or timber alternatives — smooth interior with no crevices

• Drain Valve
• Insulated Lid

Lead time and specific delivery terms were not provided in the supplier material — confirm with the logistics team before publishing.

Delivery is typically kerbside; the packed tub fits in the carry backpack (single-person carry) so no lifting equipment is required for last-metre placement. No special vehicle access is needed.

Customers should confirm a clear path to their chosen setup location prior to delivery.

The tub requires no tools to set up. Unpack from the carry backpack, unfold on a flat, level surface, and inflate using the included high-pressure pump to the recommended PSI indicated on the air valve label. Inflation typically takes 10–20 minutes with the manual pump; an electric pump (if included in your kit) reduces this significantly.

Once inflated, connect a garden hose or chiller inlet hose to the green Water In port and fill to the desired level. Attach an electric chiller via the Water In and Water Out ports if chilled water is required — no additional drilling or modification is needed. Watertight caps seal the ports when a chiller is not in use.

No plumbing or electrical work is required for manual-ice operation. If connecting a chiller, ensure a standard power outlet is accessible within reach of the chiller's cable. A single person can set up the tub in under 30 minutes.

Warranty duration and specific coverage terms were not stated in the supplier material. Please confirm warranty details before listing.

- After each use, drain the tub fully via the Water Out port and rinse the interior with clean water before deflating.
- Wipe the inner surface with a mild, non-abrasive cleaner. Avoid bleach concentrations above 10ppm or solvent-based cleaners, which can degrade the PVC.
- Before deflating for storage, ensure the interior is fully dry to prevent mould growth inside the packed tub.
- Inspect port fittings and the air valve for tightness before each inflation. Use the included plumber's tape on threaded connections if any weeping is noticed.
- Use the included PVC patch kit to repair any punctures immediately — do not use the tub with an active leak.
- Store the deflated tub away from direct UV exposure and sharp objects. The carry backpack is suitable for regular storage.